Tortuga in action

Here's my new pickup winder, Tortuga, in action on the first (new) attempt to wind this harp pickup.  It's running at about 14 RPM, which is much faster than I was able to get the Spartan to run (it had to either go much slower than this, or else it would freak and jump up to 100 RPM or something, and break the wire).  At this rate, I should have the desired number of turns within a couple of hours.  Pretty fast, for a tortuga!

I have a video of this machine in operation: https://youtu.be/u1EQmWWhWVs





Here's the completed coil: 2000 turns.




Comments

Post a Comment

Popular posts from this blog

Tortuga: a better pickup winder

Image
Slow and steady wins this race.  Even with a solid-state motor speed controller, I was unable to get the Spartan sewing machine to run slowly enough, in a reliable manner, and it kept breaking wires.  Not enough torque to overcome its own inconsistent friction, at such low power settings. So, I built this stepper motor based winder.  555 oscillator drives A4988 stepper driver, running in 1/16 microstepping mode (i.e., the slowest, smoothest mode).  I built the "circuit board" from a piece of acrylic plexiglass, with holes drilled for the through-hole components (555, A4988, and 7805 regulator), and passive components wired point-to-point underneath.  I'm proud to say, it worked at first power-up, which is not always the case! I have not yet built the spindle to attach to the shaft and hold the pickup bobbin; so far, I've just been testing the raw motor unit to make sure it can run for hours at a consistent slow speed, which it seems to do fine.  The one pro...
Read more

the Spartan pickup-winding machine

Image
Classic Spartan sewing machine from 1959, gets second job as a pickup winder.  Purrs along just like a Merlin V-12 (which they always say, runs like a sewing machine). Here's the "cruise control". So at slightly over 2 RPM, 2000 windings would take almost 17 hours.  Except that I dare not leave it running non-stop, as the control pedal gets way too hot and makes scary smells.  So I'm running it at about a 50% duty-cycle, 15 minutes on, 15 minutes off.  So, this could take several days.  Or, maybe my speed control that I ordered will arrive before this is done...
Read more